Knowledge
- 0 comments
- by John White
How Does Cold Corona Improve PP Adhesion?
For B2B factories printing on polypropylene, cold corona pre-treatment is a practical way to raise surface energy on a low surface energy substrate so UV ink can wet, anchor, and pass adhesion checks more reliably. In industrial UV printing on...
- 0 comments
- by John White
How to Build ICC Profiles for UV Prints?
For a B2B industrial UV printer workflow, custom ICC profiling is the practical way to control color on non-standard substrates such as raw wood, slate, and brushed steel. The process usually starts with linearization, then total ink limit optimization, then...
- 0 comments
- by John White
How can MES data strings drive DPM with direct part marking in an industrial UV print line?
In North America-focused manufacturing environments, integrating MES data streams directly into active print buffers enables real-time traceability for direct part marking (DPM) with UV printers. This article guides procurement engineers, OEMs, and production managers through a practical, engineering-first approach to...
- 0 comments
- by John White
How should B2B teams vet Chinese UV flatbed printer manufacturers by technical specs?
For procurement engineers and OEM production teams, a focused technical checklist reduces risk: verify frame rigidity, linear guide stability, mainboard and electronics provenance, and component longevity through multi-point engineering inspections and acceptance tests aligned to your production mix. AndresJet’s engineering...
- 0 comments
- by John White
How Much White Ink Per m² in UV Printing?
For B2B factories and OEM production teams, the right way to estimate white-ink cost is to model coverage, laydown rate, passes, and waste per square meter rather than rely on a generic ink price. In industrial UV flatbed printing, a...
- 0 comments
- by John White
How to Stop Static on Coroplast Printing?
For B2B UV flatbed and industrial sign production, static on fluted polypropylene can cause ink droplet scatter, deflection, and dust attraction during rapid linear indexing. The practical fix is not one device alone, but a controlled system: humidity control, grounding,...
- 0 comments
- by John White
How to Configure Vacuum Bed Zones for Thin Metal?
For B2B UV flatbed printing on thin-gauge sheet metal, the right vacuum bed zone configuration is less about “more vacuum” and more about controlled, targeted pressure distribution. A well-designed matrix zoning strategy helps stabilize warped plates, reduce lift at the...
- 0 comments
- by John White
Can UV Ink Survive Deep-Draw ABS?
For B2B factories and OEM production teams, the real question is not whether UV ink can print on ABS, but whether the ink film can survive the full thermoforming cycle without micro-cracking, whitening, or edge pull-back. In practice, success depends...
- 0 comments
- by John White
How to Reduce Ink Misting in High-Gap UV Printing?
In a B2B industrial UV printer environment, ink misting and satellite droplets usually become more visible when printhead-to-media distance rises above 3 mm, because the droplet flight path is less stable and the air and electrostatic environment matter more. For...